Today here we are discussing How to do canon MG3000 Wi-Fi setup. Keep reading this article to learn in-depth.
Before we begin, many conditions must be met. People could use WPS button approaches:
- The access point has to have a WPS button physically on the printer.
- Please refer to your device's user manual for details.
- When the WPS button is not available on the printer, use the instructions on the tab for the binding technique.
- In large part in WPS, you can allow access by working with this Protocol.
Solution 1:
- Make sure the printer can prepare a network.
- Hold down the [Wi-Fi] coat of arms button in addition to the printer before the alert lamp blinks once, step one is what we need to do.
Solution 2:
- Make sure the lights in the button section start flashing blue, then visit the access point for you personally and press [WPS] within two minutes, so the Akti WPS.
- For information on how to start WPS at an entry point, see the user manual for this printer.
Community Settings Confirmation
To confirm that your printer connects to a wireless network, you can also post a system configuration of your printer as needed: - Make sure your printer is turned on.
- Press and hold [Resume / Cancel] before the alert light blinks 3 times, then launch it on a button.
The network information page will be published.
When discussing this print, check that the 'Connections' reveal 'on' and the Service Set Identifier SSID [title of your wireless system for] reveals a title of your wireless network.
WPS going through the installation process.
You can configure the application to make the most of your own PIXMA MG3510.
Comments
Post a Comment